Back to FabImage Studio website

You are here: Start » Filter Reference » Camera Support » MATRIX VISION » mvGenTLAcquire_GrabImage_WithTimeout

mvGenTLAcquire_GrabImage_WithTimeout


Module: ThirdParty

Captures a frame from MATRIX VISION cameras using mvGenTLAcquire SDK.

Name Type Range Description
Input value inDeviceID String* Device name or serial number of device
Input value inTimeout Integer 10 - Maximum time to wait for frame in milliseconds
Input value inPixelFormat MVGenTLPixelFormat* Pixel format of output image
Input value inExposureTime Integer* 1 - + Exposure time value
Input value inGain Real* Gain value
Input value inFrameRate Real* 1.0 - Frame rate in FPS
Input value inAoi Box* Required fragment of image to stream
Input value inTriggerMode MvIMPACTTriggerActivation Trigger mode
Input value inTriggerSource MvIMPACTTriggerSource Source of trigger
Output value outImage Image? Captured frame

Remarks

Camera driver software

This filter is intended to cooperate with a camera using its vendor SDK. To be able to connect to a camera, it is required to install mvGenTL Acquire SDK software with camera dedicated drivers.

mvGenTL Acquire SDK software can be downloaded from the following website: www.matrix-vision.com. For FabImage Studio 32-bit, mvGenTL Acquire x86 version is needed. For FabImage Studio 64-bit, mvGenTL Acquire x86_x64 version of SDK is required.

Recommended mvGenTL Acquire SDK version for usage with FabImage Studio is 2.49.0.

Camera identification

When there is only one camera connected to the computer, field inDeviceID can be set to Auto. In such case, first available camera will be found and connected.

inDeviceID can be used to pick one of multiple cameras connected to the computer. inDeviceID can be set to:

  • serial number - it should be specified on the device casing(e.g. GX001559),
  • product name - it finds camera by name (might be the same for many cameras). The product name is a bit more specific than the family name, but less specific than the serial number(e.g. mvBlueCOUGAR-X100wG),
  • product number - it finds camera by family name(e.g. mvBlueCOUGAR).
Camera parameters

Most of the parameters exposed by camera filters are optional, setting them to Auto leaves related parameter for automatic configuration by the camera driver.

To change other and more advanced camera parameters, use the wxPropView available with mvGenTL Acquire SDK. Refer to SDK documentation for information about parameters and how to save them into memory channels.

Parallel execution

This filter cannot be placed in multiple Workers.

Complexity Level

This filter is available on Advanced Complexity Level.

Filter Group

This filter is member of mvGenTLAcquire_GrabImage filter group.

See Also