You are here: Start » Filter Reference » Camera Support » GoPxL » GoPxL_GrabLine_WithTimeout

GoPxL_GrabLine_WithTimeout

Module:	ThirdParty

Captures Line Feature data from GoPxL device.

Name	Type	Range	Description
inAddress	GoPxLAddress *		GoPxL Device identifying IP address (e.g. "127.0.0.1" or "127.0.0.1:3600") or serial number (e.g. "SN:17335")
inInputQueueSize	Integer	1 - 50000	Number of incoming frames that can be buffered before the application is able to process them
inTimeout	Integer *	10 -	Maximum time to wait for data in milliseconds
inSourceID	Integer *	0 -	ID of the data source in Gocator Protocol
outLine	GoPxLLine ?		Line
outFrameInfo	GoPxLFrameInfo ?		Frame metadata

Remarks

Device driver software

This filter is intended to cooperate with a Gocator device running GoPxL firmware. It is not required to install any additional software to connect to the device.

Device identification

When there is only one device connected, the field inAddress can be set to Auto. In this situation, the first available device will be used.

inAddress can be used to pick one of multiple devices connected to the computer. inAddress can be set to:

IP Address - GoPxL Device identifying IP address (e.g. "127.0.0.1" or "127.0.0.1:3600")
Serial Number - GoPxL Device serial number with "SN:" prefix (e.g. "SN:17335")

Gocator Protocol data source ID

When the field inSourceID is set to Auto, all data sources of a specific type would be processed by this filter. To process only one, chosen data source, set the value of this field to an appropriate ID. Data source IDs can be found in the GoPxL web interface, under Control/Gocator tab.

Complexity Level

This filter is available on Advanced Complexity Level.

Disabled in Lite Edition

This filter is disabled in Lite Edition. It is available only in full, FabImage Studio Professional version.

Filter Group

This filter is member of GoPxL_GrabLine filter group.