You are here: Start » Filter Reference » Hardware Support » Euresys » MultiCam_SetDigitalOutput
Basic| Module: | ThirdParty |
|---|
Sets digital output.
| Name | Type | Description | |
|---|---|---|---|
 |
inDeviceID | String* | Board name, board identifier or serial number |
|
inOutput | Integer | Output pin index |
|
inOutputStyle | MultiCamOutputStyle* | Controlling the electrical style of I/O lines used as outputs. If Nil then lease style as it is |
|
inOutputState | MultiCamOutputState | Issuing the logic state of I/O lines used as outputs |
Remarks
Board driver software
This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install MultiCam SDK software. Currently FabImage Studio requires MultiCam version 6.18.
MultiCam drivers can be downloaded from following website: https://www.euresys.com (registration may be required).
Supported frame grabbers:
- GRABLINK series
- DOMINO series
- Picolo series
Board identification
When there is only one board connected to the computer, field inDeviceID can be set to Auto. In such case, first available board will be found and connected.
inDeviceID can be used to pick one of multiple boards connected to the computer. inDeviceID can be set to:
- board name,
- board identifier,
- driver index,
- pci position.
Parallel execution
Complexity Level
This filter is available on Basic Complexity Level.
Disabled in Lite Edition
See Also
- MultiCam_GetDigitalInput – Reporting the logic state of I/O lines used as inputs.
- MultiCam_GrabImage – Captures a frame using Euresys frame grabber.
