You are here: Start » Filter Reference » Hardware Support » Euresys » MultiCam_GrabImage

MultiCam_GrabImage

Module:	ThirdParty

Captures a frame using Euresys frame grabber.

Name	Type	Range	Description
inDeviceID	String *		Board name, board identifier or serial number
inTopology	String *		Board topology
inCameraTapConfiguration	String *		Tap configuration of camera
inConnector	String		Indication of connector used by channel
inAcquisitionMode	MultiCamAcquisitionMode		Acquisition Mode
inCameraFile	File *		Camera configuration file
inPageLengthLn	Integer *	1 - 65535	Page Length
inColorFormat	MultiCamColorFormat		Color format
inGain	Integer *		Linear control of gain for all digitizing units
inSurfaceCount	Integer *	1 - 4096	Number of allocated surfaces
outImage	Image		Captured frame
outFrameID	Long		Captured frame ID
outTimestamp	Long		Captured frame timestamp in microseconds

Remarks

Board driver software

This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install MultiCam SDK software. Currently FabImage Studio requires MultiCam version 6.18.

MultiCam drivers can be downloaded from following website: https://www.euresys.com (registration may be required).

Supported frame grabbers:

GRABLINK series
DOMINO series
Picolo series

Board identification

When there is only one board connected to the computer, field inDeviceID can be set to Auto. In such case, first available board will be found and connected.

inDeviceID can be used to pick one of multiple boards connected to the computer. inDeviceID can be set to:

board name,
board identifier,
driver index,
pci position.

Parallel execution

This filter cannot be placed in multiple Workers.

Complexity Level

This filter is available on Basic Complexity Level.

Filter Group

This filter is member of MultiCam_GrabImage filter group.