Back to FabImage Studio website
You are here: Start » Filter Reference » Geometry 2D Normalizations » NormalizeRectangleOrientation
NormalizeRectangleOrientation
Changes orientation of the given rectangle according to parameters.
| Name | Type | Description | |
|---|---|---|---|
 |
inRectangle | Rectangle2D | Input rectangle |
|
inReferenceAngle | Real | The middle angle of the valid range of the output rectangle's angle |
|
inRectangleOrientation | RectangleOrientation | Orientation of the output rectangle |
 |
outRectangle | Rectangle2D |
Description
The operation changes the input rectangle's marked corner so the output rectangle's rotation angle is the lowest possible not lower than inReferenceAngle - 90 satisfying the inRectangleOrientation parameter at the same time. Some sample parameters configurations are:
- inReferenceAngle = 90, inRectangleOrientation = Any – the marked corner will have the least y coordinate possible
- inReferenceAngle = 0, inRectangleOrientation = Any – the marked corner will have the least x coordinate possible
- inRectangleOrientation = Horizontal – the output rectangle's width will be not shorter than its height
- inRectangleOrientation = Vertical – the output rectangle's height will be not shorter than its width
Examples
Description of usage of this filter can be found in examples and tutorial: Badge Measurement, Button Presence.
 |
 |
NormalizeRectangleOrientation performed on a sample rectangle with inReferenceAngle = 90 and inRectangleOrientation = Any.
Complexity Level
This filter is available on Basic Complexity Level.
