You are here: Start » Filter Reference » NET ICube » ICube_SetParameter
ICube_SetParameter
Sets a parameter of type Integer in an ICube device.
| Name | Type | Description | |
|---|---|---|---|
 |
inDeviceID | Integer* | Index of a camera |
|
inType | Integer | Type of the parameter to set (see Parameter Definitions in the API Header) |
|
inValue | Integer | Value to set |
Description
Sets value of the parameter specified by inType. This filter executes the ICubeSDK_SetCamParameter ICube SDK function.
Remarks
To be able to use an ICube camera, you need to install the camera driver. You can find it at the following address (select binaries):
https://net-usa-inc.com/en/usb2.0.html or https://net-usa-inc.com/en/usb3.0.html
Please make sure that the ICube SDK is installed properly on your computer. To verify the driver installation, you can run iControl.exe. If the camera was detected and you can see the image from it in this application, you can use your ICube camera in FabImage Studio.
Recommended ICube SDK version for FabImage Studio usage is v2.0.4.8.
The full description of the camera parameters can be found in the ICube SDK documentation.
Complexity Level
This filter is available on Basic Complexity Level.
See Also
- ICube_GenerateSoftwareTrigger – Generates software trigger in ICube device.
- ICube_GrabImage – Captures an image from an ICube camera.
- ICube_GrabImage_WithTimeout – Captures an image from an ICube camera; returns Nil if no frame comes in the specified time.
- ICube_SetParamAuto – Sets a parameter of type auto in an ICube device.
- ICube_SetParamOnePush – Sets a parameter of type One Push in an ICube device.
- ICube_SetTriggerMode – Sets a trigger mode in an ICube device.
