Back to FabImage Studio website
You are here: Start » Filter Reference » BitFlow » BitFlow_GetGPOutPin
BitFlow_GetGPOutPin
Gets R64 GPOUT pins state
| Name | Type | Range | Description | |
|---|---|---|---|---|
 |
inBoardNumber | Integer | Index of board | |
|
inCameraFileName | File | Camera file | |
|
inOutput | Integer | 0 - 6 | output |
 |
outState | Bool | pin state | |
Remarks
Board driver software
This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install BitFlow SDK software. Currently FabImage Studio requires BitFlow SDK version 6.30.
BitFlow SDK can be downloaded from following website: http://www.bitflow.com (registration may be required).
Running application
This filter uses camera configuration files, which are loaded to register. To load this file to register you should use SysReg application from BitFlow SDK.Complexity Level
This filter is available on Basic Complexity Level.
Disabled in Lite Edition
This filter is disabled in Lite Edition. It is available only in full, FabImage Studio Professional version.
See Also
- BitFlow_GetHardwareTriggerStatus – Gets the status of the hardware trigger
- BitFlow_GrabImage – Captures a frame using BitFlow frame grabber.
- BitFlow_SetGPOutPin – Sets R64 GPOUT pins
- BitFlow_SoftwareTrigger – Perform a software trigger
